Mex MPC-1054-FV, Инструкция по установке и эксплуатации

Страница: 18 / 24

PEN K INTER TRADING CO.,LTD. |ENG 7
Equipment Installation
1. Take a 20NB Rigid PVC riser pipe, approximately the height of the vessel and solvent cement the bottom distributor to
one end of the pipe.
2. Insert this riser pipe into the vessel and cut the pipe from the top ensuring that the height of the pipe (with the
distributor touching the bottom) is the same as the top of the vessel.
3. Pour gravel and then filter media into the vessel. Cover the mouth of the riser pipe while doing this so that media
doesn't enter the pipe. Align the riser pipe so that it is in the Centre of the vessel opening.
4. Screw on the top distributor to the bottom of the MPV.
5. Screw on the MPV to the vessel ensuring that the riser pipe goes through the top distributor into the MPV.
6. Make the inlet, outlet and drain connection.
Operation of Manual valve
1. Always press the handle down before turning the handle to the desired position viz. Service, Backwash or Rinse.
2. If the line pressure is more, it is advisable to close the inlet valve before turning handle.
Installation Procedure
The following installation procedures shall be carried out by a qualified person. Read the installation and operation
manual carefully.
Installation
1. Place the MPC-1054-FV or MPS-1054-FV system where you want to install the unit.
2. Turn off the mains water supply.
3. Connect the inlet and outlet pipe of the system correctly using piping of the suitable diameter.
4. Cut a section of plastic hose of desired length. Connect it to the drain line of the system and fasten with hose hoop.
The other end of the hose runs to a drain and is secured in place.
5. Manual valve shall be installed at the inlet/outlet of the MPC-1054-FV or MPS-1054-FV system. A bypass valve is
recommended to be installed between the inlet and outlet of the system so that normal usage of water is not affected
during the maintenance of the system.