MEV Mini Hummer HX, Руководство пользователя

Страница: 25 / 31

MEV™ Mini HUMMER HX™ OWNERS MANUAL
25
If the charger is left connected to AC power supply, a refresh charge will occur after 10 days
if the battery voltage has dropped below a pre-programmed level. If a refresh charge tries to
start, but the AC power is disconnected, the charger will wait 8 days for AC to be restored.
At this point, the charger will go into sleep mode and a DC disconnect will be required to
reset the charger.
The charger can be connected to any three prong 110-240 volt home outlet with an
available minimum 12 amps of current. To avoid the risk of electrical shorting, the battery
charger must be grounded through a properly installed three prong outlet. Do not use a two
prong adapter.
Locate all cords and wires in locations that will not be driven over or present a tripping
hazard.
Note: The cart and charger are equipped with an interlock device; the cart will not start if AC
Power is pressed. The AC power source must be disconnected first at the cart connector
located on the front bumper prior to operation.

Do not attempt to service the charger. If the charger requires service, take it to an
authorized MEV dealer or an approved technician.

Do not overload the AC circuit. The input voltage of the charger should be between 110-
240 volt and supply a current at least 12 Amps.

The AC side of the charger uses a grounded three prong plug. While charging, use a
three prong wall receptacle with a proper ground. Do not attempt to alter the charger
plug in any way.

Do not use an adapter plug to go from three prongs to a two prong outlet. This will
result in an ungrounded condition and increase the risk of electric shock and/or fire.

If an extension cord is used, it must also be a three pronged extension cord with 14 AWG
(American Wire Gauge) wires. No longer than 15m (50 feet). The longer the cable used
means the less effective the charge rate will be.

Inspect and replace the charger if it has been damaged in any way. Inspect the cords and
connectors for cracks and fraying. If cracks or frays are detected, replace immediately.

Do not use the charger near volatile liquids such as gasoline, paints, thinners, and other
flammables. The charger can ignite flammable materials and vapours.

Do not cover or block the cooling slots on the charger as it could potentially overheat.
Charger Operation instructions
1. Always connect the charger to a
GROUNDED outlet. When using an extension cord, avoid
excessive voltage drops by using a grounded, 3-wire, 14-AWG cord no longer than 15m (50
feet).
2. AVOID connecting Delta-Q charger and another device to a single 15A20A circuit or the
circuit may become overloaded.
WARNING