13. Special functions
Fig. 27: Adjusting procedure for the Ex-Zoom mode
Adjusting procedure for the Ex-Zoom mode:
• Switch off the flashgun with the main switch
(16)
for approx. 5 seconds.
1
Hold down the zoom control button
(32)
on the control unit
(2)
.
•
Switch on the flashgun with the main switch
(16)
.
• Release the zoom control button
(32)
.
•
To switch off
the Ex-Zoom mode proceed
in the same sequence
.
13.8 The „Rapid“ function
The flash recycling time in A and TTL mode depends upon the amount of light required for the
exposure. At full light output the recycling time is maximum 5 seconds. The "Rapid" function can
be switched on if this flash recycling time is too long. The "Rapid" function is recommended for
such instances where fast recycling times are more important than maximum flash output, e.g.
when indoors. The "Rapid" function lowers the guide number by 1 rating, e.g. from the guide
number 50 (at ISO 21/100° - Zoom 50 mm) to guide number 35 (at ISO 21/100° - Zoom 50 mm).
Partial light outputs are not possible in the "Rapid" function!
13.9 The ML function (modelling light)
The
ML (19)
button triggers a modelling light of approx. 4 seconds. This is particularly useful
in the remote control modes because it becomes possible to assess the shadow conditions
(densities). If
ML
is triggered on the control unit, then only the type 50 MZ-5 slaves will
simultaneously emit this modelling light. Press the
ML
button
(19)
for at least 2 seconds to
trigger the modelling light. Release the
ML
button
(19)
when the modelling light is emitted. To
interrupt light output press the
ML (19)
button once again.
A fully charged battery is sufficient to trigger the modelling light some 60 times.
40
1
☞
☞
Содержание Mecablitz 50 MZ-5
Страница 1: ...Rapid TV VIDEO CAMCORDER MECABLITZ MECABLITZ 50 MZ 5 Operating Instructions ...
Страница 13: ...Notes 13 ...
