-
6
-
CONNECTING THE DEVICE
1. Prepare the Skin
Prepare the skin as previously discussed and according to instructions provided with
your electrodes. Before attaching the electrodes, identify the area in which your medical
practitioner has recommended for electrode placement.
2. Connect lead wires to the electrodes
Connect the lead wires to the electrodes before applying the electrodes to the skin.
Note: Be sure both intensity controls for Channel 1 and 2 are turned to the “OFF”
position.
3. Place Electrodes on Skin
Place the electrodes on the skin as recommended by your clinician.
4. Insert Lead Wire Connector to device
Plug end of lead wire into the channel output receptacle to be used, pushing plug in as
far as it will go.
5. Select Treatment Settings
Check and be sure your unit is set to the proper settings as recommended by your
medical practitioner.
6. Adjusting Channel Intensity Control
Locate the intensity control knobs at the top of the unit. Slowly turn the intensity control
knob for Channel 1 clockwise until you reach the intensity recommended by your
medical professional. Always start with the lowest step and increase slowly. Repeat the
same process for Channel 2, if appropriate.
If the stimulation levels are uncomfortable or become uncomfortable, reduce the
stimulation intensity to a comfortable level. Cease stimulation and contact your
medical practitioner if problems persist.
BATTERY INFORMATION
A 9-volt disposable battery is provided with your unit. When the low-battery indicator
appears, the battery has become too weak to power the unit and will need to be
replaced. At this point, the unit will shut off until a fresh battery is inserted.