5
TABLE 2
Recommended VPVL Lubricants
Kluber UniGear LA 02 Grease
Esso (Exxon) Beacon EP2
Fina Marson EP L2
General Use
Shell Alvania EP2
Mobilux EP2
Dyrdene Pyroplex EP2
Oilsum Multiplex
O-Ring Areas
Dow-Corning Silicone 111
Parker Super-O-Lube
1. Drive Shaft (60) Assembly, (Figures 8 & 9):
A. Install the top and bottom shaft bearings (6, 7)
and o-rings (21, 22) onto the shaft (60).
B. Apply grease to the shaft bearings (6, 7), using a
general purpose grease listed in
(Table 2)
. Apply
silicone grease to the shaft o-rings (21,22) using
the recommended o-ring-area grease listed in
(Table 2)
.
C. Partially Insert the shaft (60) into the body (50).
Install the octi-cam (1) onto the shaft in the
orientation shown in
(Figure 9)
. The edges of the
octi-cam (1) should align with the edges of the
square in the bottom of the shaft (60). Insert the
internal thrust bearing (8) over the octi-cam (1).
Fully insert the shaft into the body (50).
D. Install the external thrust bearing (8), thrust
washer (10), and the spring clip (18).
2. Piston (40) Assembly, (Figures 10 through 13):
A. Install the piston o-ring seal (16) and the piston
head (15) and piston back (5) bearings.
B. Apply silicone grease to the internal bore of the
body (50) using a recommended o-ring area
grease listed in
(Table 2)
. Apply grease to the
piston (40) rack teeth using a recommended
general-purpose grease listed in
(Table 2)
.
C. Hold the body (50) in a horizontal position by
inserting the top of the shaft in a vice, or inserting
the bottom of the shaft connection into a male
drive fitted into a vice as shown by
(Figure 10)
.
60
6
21
Figure 9
18
8
1
8
10
Figure 8
20
7
Driver Square (60) –
OCTI Cam (1)
Alignment
60
1
50
Figure 10
60
50
