METRUM ComMi, Руководство по установке

Страница: 13 / 20

ComMi
© 201 9 Metrum Equipamentos de Medição e Testes LTDA. All rights reserved. 13
2. Unleash approximately 6mm of wire;
3. The power wires should be connected to the circular terminals 1 and 2 of the
connector, as shown in Figure 9, where the positive is terminal 1 and negative is
terminal 2;
Figure 9 – Terminals
4. Insert the precision screwdriver into the rectangular hole of the connector above
the terminal to which the wire is to be attached to compress the spring of the internal
mechanism of the connector, as shown in Figure 10-a;
5. While the precision screwdriver pressures the spring compression, insert the bare
end of the wire into the desired terminal as shown in Figure 10-b;
6. Remove the precision screwdriver, keeping the wire attached, as shown in Figure
10-c;
7. Check if the wire is securely attached to the connector.
5.5 Turning the device on
1. Check that the voltage is within the specified limits;
2. Power the device through connector "3" in Figure 2.