All-Engineering BV
https://metrumacoustics.com
[email protected]
Operation
Remark:
When the ADAGIO is fully connected and
switched”
on” the volume knob will turn anti clockwise to the lowest
position. The mute function will be activated the very first time.
To release the mute function one of the remote-control buttons
should be used randomly. In case of disconnecting the ADAGIO
from the mains power, this procedure should be repeated.
•
Standby:
To reduce power the DAC board will be switched off in stand-by mode. Just the
front panel is activated to control the system. Power consumption will be reduced to 0.5
Watts. Any control is possible by using the front button or remote control.
•
Mute function:
By switching to one of the digital sources the mute function will be released
after five seconds. When switching the ADAGIO to “standby mode” muting will be active
again. When the ADAGIO is operational you can use the mute function only by using the
remote control. In this situation, the JADE shows you the selected digital source but also the
red “Standby/ mute” light will lit. By using one of the volume buttons the mute function is
released.
•
Source selection:
The digital inputs can be selected by using the only available button at the
front
. When switching the ADAGIO to “On”, the first channel (AES/EBU) will be selected.
When pushing this button repeatedly
, the next “coax” input will be selected followed by
“Optical” and “USB”. The next step is back to “Standby” Note: When
moving fast trough the