metrotek Bercut-ET, Руководство по эксплуатации

Страница: 105 / 116

105
B. Remote control commands
Table B.1. Remote control commands (console)
Command Description
AT empty command, used to check connection
ATR restart the device (analyzer)
ATM1 RFC 2544 test results and settings output
ATM2 BERT test results and settings output
ATM3 display measurements results and settings for the packet jitter
ATI display device information
ATH display command’s help
ATS
enter the option activation key. The key is a decimal number which
should be typed in right after the
ats command, without any spaces.
ATC switch to the test configuring and running mode (optional feature)
Table B.2. Remote management commands (TELNET). Show mode
Command
Information displayed in console
RFC 2544
show rfc2544 header src udp source UDP-port number
show rfc2544 header src mac source MAC address
show rfc2544 header src ip source IP address
show rfc2544 header dst udp destination UDP-port number
show rfc2544 header dst mac destination MAC address
show rfc2544 header dst ip destination IP address
show rfc2544 header vlan enabled
show whether VLAN parameter is enabled
show rfc2544 header vlan id VLAN identifier value
show rfc2544 header vlan priority traffic priority value
show rfc2544 header precedence frame priority value
show rfc2544 header tos type of service for the packet
show rfc2544 topology port tx transmitting port
show rfc2544 topology port rx receiving port
show rfc2544 throughput duration throughput trial duration
show rfc2544 throughput enabled show whether throughput test is enabled
show rfc2544 throughput maxrate maximum rate for the throughput test
Bercut-ET. Operations manual