METROTEC
11
7
Configuration
Configuration changes can be carried out on location while only limit value and measured
value adjustments can be performed without
METROTEC U15 App for Android
Smartphone
Note:
In order to implement extensive changes and to display measured values, the "METROTEC
U15 App" for Android Smartphones is required.
7.1
Enabling Configuration
The configuration will be enabled by pressing "T1" until the bottom LED of the left LED
array lights up. See Table 2, Figure 2.
See also sections "Correction of Measured Values" and "Limit Value Setting"
Table 2: Status display of left LED array
No settings
possible
Adjustment mode for
reference point
Adjustment mode for
Measured value
Setting mode for
Limit value
Figure 1
Figure 2
Figure 3
Figure 4
--------
LED flashes while value is being changed via "T3" or "T4".
7.2
Correcting the Measured Value
The current measured value can be corrected, if required. In this case it is advisable to make
the adjustment after a stable measurement has been achieved and possible errors in
measurement can be ruled out.
The adjustment will be started by pressing "T1" until the bottom LED of the left LED array
lights up. See Table 1, Figure 2.
The measuring module has now switched the reference point to the measuring output. If
required, the measuring output will also be set to the midpoint of the measuring output range.
