Metrologic MS6720, Настройка

Страница: 1 / 12

MDE-4354 Setting Up Metrologic® MS6720 Bar Code Scanner • August 2005 Page 1
Introduction
Your bar code scanner has been programmed at the factory and should be ready to operate.
This document contains a verification sequence that allows you to determine whether your
scanner is programmed correctly and a programming sequence to follow if it is not
programmed correctly.
Setting Up the Scanner
1
Turn off power to the Profit Point POS terminal.
2 Unplug the AC power to the POS distribution box power supply.
3 Remove the scanner power supply from the shipping box and discard per local practice.
4 Open the MCA cover, make the following changes, then close the cover.
• Remove jumper/shunt from JP2 and discard (see Before in Figure 1 ).
• Move jumper/shunt from JP1 pins 2 and 3 (see Before in Figure 1 ) to JP1 pins 1 and 2 (see
After in Figure 1 ).
• If contained in shipping box, place power supply connector cover on power supply
connector on MCA (see After in Figure 1 ).
CAUTION
Be aware of the following:
• When an IEE
®
customer display is used, the scanner will be operating at the 9600 baud rate.
• When an Ultimate Technology
®
customer display is used, the scanner will be operating at the
1200 baud rate.
• For Datalogic DLL2020 scanners, refer to MDE-4389 Setting Up Datalogic DLL2020 Bar
Code Scanner Used on Profit Point Terminal.
CAUTION
Before proceeding, make sure the Metrologic
®
Connector Adapter (MCA) is not connected to the
scanner, communication cable, or host.
MDE-4354
Setting Up Metrologic
®
MS6720 Bar Code
Scanner
August 2005