1.
With the exception of the wire shelf (see below), all
accessories that mount directly to the uprights are
attached in the same manner. Locate the Allen head
bolts and the rectangular nuts that are provided with
each accessory.
2.
Insert the bolts through the mounting flange of
the accessory and attach the nuts to the bolts by
threading them on just a few threads. Make certain
that you thread the bolts into the nuts on the side of
the nut that has the double-serrated grooves on either
side of the threaded hole.
TypIcAL INSTALLATION fOR
UpRIGhT mOUNTED AccESSORIES
1.
Install the light support arms per instructions for upright mounted accessories (shown at top of page).
2.
Position the light fixture below the support arms and attach to the
brackets following the same process as the assembly
of upright mounted accessories.
note:
If tool track
accessory is also to be mounted from support arms,
position front of light fixture at least 4" in on either side
of support arms.
3.
To install bulbs, remove the two light diffuser
positioning screws from the
front underside
of the
light fixture. The screws are located approximately
1
/
3
of the way in from the end of
the fixture.
4.
To expose the bulb socket, slide the light diffuser forward
to allow the diffuser to drop out of the fixture at the rear.
5.
Install the bulbs; replace the diffuser and reinstall the screws.
OvERhEAD LIGhT
BulBs not
included
1.
Determine whether the wire shelf will be installed
horizontally or pitched (see below).
1.
Install the tubular shelf
supports per the
instructions above
for upright mounted
accessories.
2.
Position the laminate
shelf on top of the
supports; attach the
shelf to the supports
by inserting the wood
screws through the
holes in the tubular
supports and screw-
ing them into the
underside of the
laminate shelf.
LAmINATE ShELf
wIRE ShELf
TwO (2) 48" 40 wATT T8
fLUOREScENT BULBS REqUIRED.
3.
Position the accessory on the upright in the desired location. Orient the rectangular nuts vertically so that
they will fit into the slot in the upright. Insert the Allen wrench into the nut and begin to tighten the bolt.
Make certain that the nut rotates a full 90
° behind the flanges of the upright.
Check that the accessory
is at the desired position before tightening the bolt completely.
Page 3
2.
Position the mounting
brackets in the desired
orientation and assemble
with the rectangular
nuts as shown above,
also using the Philips
head screws and flat
washers included in the
hardware bag.
Note:
The short flanges
of the mounting brackets
should face inward when
properly installed.
3.
Position the shelf on
the mounting brackets
and attach by inserting
two screws at each end
through the shelf and
threading into the bracket.
There are three narrowly-
spaced wires running front-to-back on the shelf; the
screws should go between the first and second wires
(starting from the outside edge of the shelf).
pitched
horizontal
