Doc#
M9344 • REV K
(April 2022) Page
7 of 8
8201-001, Conduit Union
Fits between transmitter and 8200-001 conduit elbow to facilitate installation and
wiring where there is not enough room to rotate the elbow. Suitable for Class I, Div.
1 (Grps A, B, C & D) and Class II, Div. 1 (Grps E, F & G), hazardous areas. Material: zinc
plated steel.
7084-001, Stainless Steel Flange Mount Adaptor
Provides a means to surface mount transmitters rather than NPT stud (½”: NPT center
hole). Three equally spaced 6.6 mm (0.26’) diameter mounting holes on 38 mm
(1.50”) diameter circle.
7084-002, Flange Mount Adaptor
Same as 7084-001, except center hole is ¼” NPT. Material: stainless steel
8253-002, Bushing
Bushing for ½” NPT mount when screwed onto standard ¼” NPT base. Material: stain
-
less steel.
8169-75-002-XXX, Two-wire, Cable Assembly
2 conductor (20 AWG) twisted, shielded PVC jacketed cable, with plated steel grip for
cable strain relief, male ¾” NPT end. Specify -XXX for length in feet. Example: 8169-
75-002-010 =10 ft (3.1M). Material: zinc plated steel.
93818-004, Cable Grip Strain Relief Fitting
3/4” NPT male thread to cable grip. Diameter range: .156” to .25”. Complete with
sealing ring, locknut and hot dip / mechanically galvanized finish. Suitable for NEMA 4
enclosures.
93818-018, Armored Cable Grip Strain Relief Fitting
3/4” NPT male thread to cable grip. Armor diameter range: .40” to .50”. Complete
with sealing ring, locknut and a hot dip / mechanically galvanized finish. Suitable for
NEMA 4 enclosures.
CONNECTION
OPTIONAL ACCESSORIES
The ST5491E is available with different mounting options. The performance of the transmit
-
ter does not change (except for the dynamic output option, discussed).
MOUNTING
