ABTI-CH2
©Copyright 2007 Metra Electronics Corporation
1-800-221-0932
www.metraonline.com
ABTI-CH2
©Copyright 2007 Metra Electronics Corporation
1-800-221-0932
www.metraonline.com
4
ABTI-CH2
ABTI-CH2
A
AP
PP
PL
LIIC
CA
AT
TIIO
ON
NS
S::
* READ IMPORTANT WARNING ON PAGE 1
BEFORE ATTEMPTING ANY INSTALLATION
Chrysler Pacifica 2004-2007
CHRYSLER
BLUETOOTH
INTERFACE
INSTALLATION
MANUAL
10)
Secure all components, and reinstall the radio.
11)
Reconnect the vehicle battery.
6)
Connect the white 8-pin plug on the IHF-1000 cable to the
vehicle interface cable.
UNP
LUG
EX
IST
ING
EX
IST
ING
RE
-PL
UG
FROM CAR
FROM CAR
20
W
AY
ABTI-CH2
10 p
in d
in
10 p
in c
ap
10 p
in p
lug
Chr
ysle
r ca
ble
harn
ess
8 pin
IHF-1000 keypad
plug
White
To
AMP
7)
Run the two wires with exposed terminals to the amplifier,
which is typically mounted on the rear passenger side. Install the
terminals in the connector as show in the diagram.
UNP
LUG
EX
IST
ING
EX
IST
ING
RE
-PL
UG
FROM CAR
FROM CAR
20
W
AY
ABTI-CH2
10 p
in d
in
10 p
in c
ap
10 p
in p
lug
Chr
ysle
r ca
ble
harn
ess
8 pin
IHF-1000 keypad
plug
White
To
AMP
8)
Install the IHF-1000 keypad on the dashboard of the vehicle,
and route the wire to the IHF-1000 harness. Attach the keypad
connector to the harness.
9)
Install the IHF-1000 microphone in an appropriate location (see
IHF-1000 instructions), route the wire to the IHF-1000 harness, and
attach the microphone connector to the harness.
Rear Amplifier
Connector Location
AUDIO WIRES FROM INTERFACE CABLE
AMPLIFIER AUDIO CONNECTOR-
ADD TWO WIRES IN THE POSITION SHOWN BELOW
OPERATION
Refer to the IHF-1000 manual for operation. All audio signals from
the IHF-1000 will be played through the car stereo. Adjust the vol-
ume using the radio’s volume knob to a comfortable level. Audio
from FM, CD, Satellite etc. will be automatically paused or muted
while calls are in process. The vehicle’s radio does not need to be on
for IHF-1000 operations, but the vehicle’s ignition must be on or in
accessory mode.
REV. 08/08/07
INSTABTI-CH2
The ABTI-CH2 Chrysler Bluetooth interface is designed
to allow full integration of Motorola’s IHF-1000
Bluetooth Hands free kit with Chrysler Pacifica vehicles.
The kit will allow users to listen to phone calls through
their car stereo. The currently playing radio source will
be automatically muted, and the phone volume may be
controlled by the radio.
