10
99-7612
Wiring Instructions
*Important: Before beginning any of the following, disconnect the negative battery
terminal to prevent an accidental short circuit.
1.
Plug the
black
16-way connector into the 99-7612.
2.
Plug the
black
12-way connector into the 99-7612.
3.
Plug the
white
16-way connector into the factory harness.
4.
Plug the 3.5 jack into the aftermarket radio.
SWC Programming
Note: Programming must take place within 20 seconds of turning the ignition on.
1.
Hold the Volume Down button on the steering wheel for at least 25-seconds until the
lights on the kit start to flash.
2.
Tap volume up to program the radio type.
Note: Lights on kit will blink to
corresponding number of button presses. Use the following chart to choose
which type of radio you are programming.
1st LED flash is for Eclipse
2nd LED flash is for Kenwood**
3rd LED flash is for Clarion
4th LED flash is for Sony and Dual
5th LED flash is for JVC
6th LED flash is for Pioneer and Jensen
7th LED flash is for Alpine*
8th LED flash is for Visteon
9th LED flash is for Valor
10th LED flash is for Clarion 5V
3.
Once you choose your radio type hold volume down for 5-seconds to finish programming
the steering wheel controls.
Note: The kit will confirm the radio type by the number
of times the lights blink.
