REV. 4/16/2019 INST99-5840CH
11
1.
Refer to step 2 from the
Installation
section.
2.
Press the push-to-start button to start the vehicle.
Note:
If the Push-to-Start module in the center console has been disconnected, reconnect it.
3.
Program the kit:
a.
Once the touchscreen display loads up, select the vehicle type.
b.
Wait until the radio comes on, and the touchscreen display shows
SWC Configured
.
This process may take up to 3 minutes.
Note:
If the touchscreen display does not load up, or the radio doesn’t come on within
3 minutes, and/or the touchscreen display does not show
SWC Configured
, check all
connections, then reset the interface and try again. Refer to the
Troubleshooting
section.
4.
Cycle the key off. If the driver’s door is closed, open and close the door. Cycle the key back on.
5.
Test all functions of the installation for proper operation, before reassembling the dash.
1.
Connect the
USB cable
attached to the
radio trim panel with touchscreen display
, to the
USB port in the back of the radio, if applicable.
2.
Secure the completed assembly into the upper dash using the factory hardware removed in
step 12 of dash disassembly.
3.
Snap the
radio trim panel with touchscreen display
over the completed assembly, and then
reassemble the dash in reverse order of disassembly.
PROGRAMMING
FINAL ASSEMBLY
