99-3309B
Axxess Interface
Installation
From the 16-pin harness:
• Connect the
Red
wires to the ignition/accessory
wire of the aftermarket radio.
• Connect the
Orange/White
wire to the
illumination wire of the aftermarket radio. If the
aftermarket radio has no illumination wire, tape off
the
Orange/White
wire.
• Connect the
Blue/White
wire to the amp turn on
wire of the aftermarket radio.
• Connect the
Brown
wire to the mute wire of the
aftermarket radio. If the aftermarket radio does not
have a Mute wire, tape up the
Brown
wire.
• Connect the
White
wire to the left front positive
speaker output of the aftermarket radio.
• Connect the
White/Black
wire to the left front
negative speaker output of the aftermarket radio.
• Connect the
Gray
wire to the right front positive
speaker output of the aftermarket radio.
• Connect the
Gray/Black
wire to the right front
negative speaker output of the aftermarket radio.
• The
Violet
wire is not used in the application.
• The
Violet/Black
wire is not used in the application.
• The
Green
wire is not used in the application.
• The
Green/Black
wire is not used in
this application.
The following wires are for the aftermarket radios that
have navigation built in:
• Connect the
Light Green
wire to the parking brake
wire of the aftermarket navigation radio.
• Connect the
Blue/Pink
wire to the VSS or speed
sense wire of the aftermarket navigation radio.
• Connect the
Green/Purple
wire to the reverse wire
of the aftermarket navigation radio.
From the 44-way harness:
• Connect the
Black
wire to the ground wire of the
aftermarket radio.
• Connect the RCA’s to the AUX in on the aftermarket
radio (if equipped).
Note:
This will allow you to retain the 3.5 AUX JACK
in the console.
• Connect the
Yellow
wire to the 12-volt constant
wire of the aftermarket radio.
• If the vehicle is amplified disconnect the 4-pin
harness located between the 44-way and 22-way
connector and connect the supplied 4-pin to 4-pin
resistor pad.
• Cutting tool • Crimping tool • Tape • Connectors
(butt-connectors, bell caps, etc.)
TOOLS REQUIRED
• 4-pin to 4-pin resistor pad harness • 16-pin with
stripped leads • 22-pin to 44-pin Camaro Harness
• 18-pin to 10-pin HVAC Harness
INTERFACE COMPONENTS
FEATURES
• Provides accessory (12-volt 10-amp)
• Retains R.A.P. (Retained Accessory Power)
• Used in amplified or non-amplified systems
• Retains all warning chimes
• Provides NAV outputs (parking brake, reverse,
mute, and V.S.S.)
• Retains OnStar/OE Bluetooth
• Adjustable volume for chimes and OnStar
• High level speaker input
• Micro “B” USB updatable
• Retains balance and fade
Installing the interface
