Metos WKI, Инструкция по установке и эксплуатации

Страница: 13 / 93

19.11.2002 Rev. 2.0
Operation instructions
7
4. Operation instructions
4.1 Before using the appliance
4.1.1 Preparing the operation
The following procedure should be carried out before a new appliance is used.
Manual filling (WKT-HA, WKT-D)
• Remove the cover of the storage water heater
• Fill the storage water heater with water, till the mark on the litre index scale. Never
overfill the reservoir.
• Replace always the cover of the storage water heater.
• Put the plug fitting in the socket and switch the machine on by turning the thermo-
stat (F) to the required temperature.
• The indicator light (E) will now light up until the water has reached the correct
temperature.
• When the indicator light goes out, the storage water heater is ready for use. During
use the indicator light will regularly go on and off, to show that the water is heating
up.
• Check regularly (after draining of hot water) if the water heater needs refilling.
Draw off an amount of hot water, when the machine is used for the first time.
Water connection (WKT-VA)
• Connect the water supply hose to the swivel joint at the back of the machine and
to a manually operated water stop valve. Attention! use cold water only.
• Open the manually operated water stop valve and check that the swivel connec-
tions are not leaking
• Open the swivel joint (H) on the upper side of the machine, the storage water heater
will fill up. The float mechanism stops the filling if the storage water heater is full.
• Put the plug in the socket and switch the machine on by turning the thermostat (F)
to the required temperature.
• The indicator light (E) will now light up until the water has reached the correct
temperature.
• When the indicator light goes out, the storage water heater is ready for use. During
use the indicator light will regularly go on and off, to show that the water is heating
up.
Draw off an amount of hot water, when the machine is used for the first time.