Metos Excelso, Руководство по эксплуатации

Страница: 6 / 9

6
05/2007 Rev. 1.0
5. FIRST TIME USE
This chapter will explain the coffee brewing and hot water system process: when the appliance is used for the
first time. when the appliance has not been used for more than one week, for example after a holiday period.
1. Slide the empty basket filter into the appliance.
2. Pour one jug of cold water into the water reservoir and place an empty jug (with lid)
underneath the filter.
3. Wait for three minutes so that the entire heating system can de-aerate.
4. Pace the plug in the socket and turn the machine on with the main switch (fig. 3C or 4C)..
5. The brew indicator light (fig. 3A or 4A) will now light up until the appliance has run though.
When the light goes out again and jug has been emptied the appliance is ready for use..
Tip: In case the light does not light up, there will probably be some air inside the system.
Check the supply down in the water reservoir (fig.5), there might be some air bubbles inside.
In that case the have to removed with, for instance, a pencil.
6. MAKING COFFEE
Basic instructions for brewing coffee
Use fine-grind coffee
Keep the jugs and the basket filter
clean
Only use fresh cold water to fill
the water reservoir
1. Place a sheet of basket filter paper (90/250) containing the desired amount of coffee (fine grind type) in the
basket filter and slide it into the appliance. See the table above for the amount of coffee required.
2. Pour one jug of cold water into the water reservoir and place an empty jug (with lid) underneath the filter.
Attention: fill the machine with minimal ½ a jug of water, otherwise the brewing process will not start!
3. Switch on the appliance using the on/off switch (fig. 3C / 4C). The lower hot plate (*) will also switch on.
4. The brew indicator (fig. 3A / 4A) will light up and the coffee brewing process will begin.
5. When the alarm lamp goes out again, the hot water supply will stop..
After about 1 minute, all of the coffee will have poured through the filter.
6. Stir the coffee in the jug briefly and pour the coffee out, or place it on the upper hot plate (*). The upper hot plate
is switched on separately using switch (fig. 3B).
Always switch off the extra hot plate when it is not being used
.
7. Once the basket filter has been cleaned you can immediately resume making coffee.
(*)if present
7. MAINTENANCE
Jug Glas Thermos
Vater
1,8 liter 1,8 liter
Coffee
125 g 125 g
WARNING
Stay near the machine while maintenance is being carried out..
When descaling the machine, always observe the instructions for use provided with the descaling
agent.
When descaling the machine, it is advisable to wear safety goggles and protective gloves.
Allow the machine to run through at least three times after it has been descaled.
Wash your hands thoroughly after descaling.
The machine should not be submerged or sprayed.
Never clean the hot plates (if present) with an abrasive or sharp object. This way scratches on the
teflon surface will be prevented.
ave all repairs carried out by a specially trained technician.
Fig 5