Metos Econo BD-600W, Инструкция по установке и эксплуатации

Страница: 5 / 12

4
28.09.2012
Freezer Metos Econo BD-600W
If the appliance has been moved, wait for a while before switching it on again. In particular,
if it was not handled vertically, you need to wait at least 2 hours.
Remove the plastic protection from the external surfaces. Wash the inside part with luke
warm water and mild soap. Place the appliance as far as possible from heat sources. Do
not prevent air from circulating inside the engine compartment. Keep the keys for locking
doors away from children.
2.2 Preliminary electrical checks
Before making the connection to the mains, ensure that the voltage and frequency are as
indicated on the appliance nameplate.
Make a visual inspection to ensure that the sockets and connections are correct.
Disconnect the socket from the mains using the main switch.
Check that the socket is suitable for the appliance plug. If necessary, the socket should be
replaced with an appropriate one by quali
fi ed personnel. Check that the plug is plugged into
the socket.
2.3 Start-up
After the above controls have been thoroughly completed the appliance may be started-up:
Turn the main switch, connected to the power cable plug, to the ON position.
Turn the switch of the appliance to the ON position. Compressor will start in apprx. 5
minutes.
Do not load the appliance until the set temperature value has been reached.
Ensure proper air fl ow.
3. Use
Proper storage of foodstuffs is a relevant factor in the safe and sanitary production of food;
in addition, it improves the ef
fi ciency of foodservice activities and positively affects energy
consumption. Follow the directions below to obtain the highest performance possible out of
your appliance.
Products should always be stored on the shelves; do not place products on the cabinet’s
bottom.
Follow alway rhe recommendations for storage of deep-frozen products.
Place the products into the appliance in such a way that proper air fl ow is ensured. Leave
free space between the products. Do not place the products in touch with the walls.