METHVEN Satinjet Waipori WASSCPGR, Руководство по установке, Страница: 2 / 2

Apply thread tape (or similar) to the ½" connection,
then screw the top rail connector to the connection.
Screw the bottom rail connector to a wall stud
making sure it is vertically in line with the top rail
connector. Maximum centre distance between the
top and bottom shower connections is 800mm.
Check the grub screws are wound out. Push the rail
brackets onto the top and bottom rail connectors
until they are against wall. Secure with grub screws.
1. 2. 3. 4.
5.
Clean filter washer
periodically.
CLEANING
Do not use any
sharp objects to
clean nozzles
Filter Washer
Ball Joint
800mm
Bottom Rail
Connector
Top Rail
Bracket
Bottom Rail
Bracket
Remove the protective cap from the showerhead ball
joint and screw the unit onto the overhead arm
ensuring the filter washer is in place.
Make sure a washer is in both ends of the hose.
Screw hose onto lower outlet on wet rail, attach
handset and place firmly in holder. Tilt and rotate
head to the desired position.
6.
Min 10mm
Max
○ 25mm
Backflow
Prevention
Device
WATER INLET: RECOMMENDED MINIMUM HEIGHT OF
1800mm FROM FLOOR LEVEL
Water Inlet
Connector
Water Inlet
Connector
Install a ½" male threaded connection at the
recommended height on wall, ensuring that a
minimum of 10mm of thread protrudes past the
finished wall.
Never use abrasives or abrasive cleaning agents to
clean this product. To clean the chrome-plated surface
use contamination free warm soapy water and a damp
soft cloth.
Lime deposits can be prevented from forming on the
faceplate by wiping immediately after use.
Clean face plate using a brush with soft bristles.
Do not use any sharp objects to clean nozzles.
Clean filter washer located in the hose cone on the
water outlet end, and in the overhead periodically.