Inlet Connector
Rail
Rail
Slider
Slider
Rail End Cap
Grub Screw
Mounting
Screw
Bottom Rail
Connector
Elbow
Grub Screw
Soap Dish
Soap Dish
½" BSP Nipple
(Not Supplied)
Connecting Nipple
Grub Screw
Grub Screw
Mounting
Screw
Inlet Connector
Bottom Rail
Connector
Mounting
Screw
•
This product must be installed in compliance with all relevant regional regulations.
•
It is the responsibility of the installer to ensure a waterproof seal is achieved between the
product and mounting surface. If in doubt about the quality of the seal, remove the product
and reinstall using silicone to ensure a seal is achieved.
•
All pipe work must be thoroughly flushed prior to the installation of the hose.
•
After installation all connections must be checked for leaks.
•
All outlets used primarily for personal hygiene shall deliver water at a safe temperature as
per regional regulations.
Wet Rail
Step 1
• Install ½” BSP nipple
at the desired
top
bracket
position.
• Wall lining hole should
be cut or finished as
per the dimension
shown in the diagram
on the right.
• Cut off the threaded
nipple 13±2mm from
the wall lining and
apply thread seal tape
to ensure a good seal.
Step 2
• Screw the inlet
connector onto the
nipple.
Step 3
• Slide the soap dish and
bottom rail bracket
onto the rail. Check the
grub screw is located
on the bottom side of
the rail bracket.
Dry Rail
Step 1
• Fix the connecting nipple
to the wall at the desired
top bracket position using
the mounting screw
provided.
• Screw the inlet connector
onto the nipple.
Step 2
• Slide the soap dish and
bottom rail bracket onto
the rail. Check the grub
screw is located on the
bottom side of the rail
bracket.
• Ensure that the washer is
in the rail end cap and
screw it to the bottom of
the rail.
Step 3
• Install ½” BSP
nipple at the desired
elbow
position.
• Wall lining hole should be
cut or finished as per the
dimension shown in the
diagram on the right.
• Cut off the threaded
nipple 13±2mm from the
wall lining and apply
thread seal tape to ensure
a good seal.
• Screw the elbow onto the
nipple ensuring that the
o-ring is sufficiently
compressed to create a
watertight seal.
IMPORTANT:
Please read all of the instructions before installation.
General:
Installation:
13±2mm
26mm
max
13±2mm
26mm
max
Wet Rail Installation
Dry Rail Installation
