P romix S ingle Lever S ink and B asin Mixer
with adjustable cartridge for flow and temperature
28391 5
Issue: N
P age 1 of 2
Im portant – P leas e read all of the ins tructions before ins tallation
T he S ink Mixer is designed for All P ressure systems.
T he B asin Mixer is designed for Mains P ressure systems only.
R ecommended water supply temperature range is 5 to 65 ° C , maximum 80° C . T hese mixers are not recommended for use
in uncontrolled heating systems such as wetbacks or solar heater units unless a NE F A tempering valve is fitted. AS /NZS
35 00 requires all hot water supplies to any sanitary fittings to be tempered to 5 5 ° C for NZ , and 5 0° C for Australia.
A L L P IP E W O R K M U S T B E T HO R O U G HL Y F L U S HE D P R IO R T O INS T A L L A T IO N O F T HE M IX E R . A N INL INE F IL T E R
M U S T B E F IT T E D T O P R E V E NT F O R E IG N P AR T IC L E S D AM AG ING T HE C E R AM IC C AR T R ID G E .
T echnical s pecifications
O perating P res s ure: Min: 35kP a, Max 1 000kP a.
R ecommended 1 5 0 – 5 00kP a. Install a NE F A pressure limiting valve if supply pressure exceeds 1 000kP a.
Inlet C onnections : All ½” B S P
Ins tallation Ins tructions S ink M ix er
A 35mm diameter hole is required in the bench top.
T he bench top cannot exceed 40mm thick.
S crew the mounting studs into the bottom of the sink
mixer.
C onnect the flexible inlet hoses to the mixer body. T he hot
hose is marked with red stainless braiding.
F it the base ring and O ring to the base of the sink mixer.
P lace the hoses through the bench.
F it the mounting gasket, the mounting plate and tighten
the mounting nuts.
T wo rubber washers are provided for the flexible hose
connections to the nipples. Machined nipple ends are
required to ensure a seal to the flexible hose nuts
Ins tallation Ins tructions B as in M ix er
A 35mm diameter hole is required in the bench top.
T he bench top cannot exceed 40mm thick.
S crew the mounting studs into the bottom of the basin
mixer.
C onnect the flexible inlet hoses to the mixer body. F it the
O ring to the base of the basin.
P lace the hoses through the bench.
F it the mounting gasket, the mounting plate and tighten the
mounting nuts.
T wo rubber washers are provided for the flexible hose
connections to the nipples. Machined nipple ends are
required to ensure a seal to the flexible hose nuts
Hos e R equirem ents
