Filter Washer
Once both end brackets have been secured, push empty
rail through end bracket, until end is part way between
end brackets, then install slider, soap dish and hose
retainer.
When rail components have been installed, push the rail
through the second end bracket.
To secure the rail, place the small black rubber stopper
into the threaded hole in the front of the end bracket,
then fit the small brass screw and tighten using a screw
driver, until tight against the rail, do not overtighten, then
fit chrome caps.
Fit hose seals to both ends of shower hose.
Thread the hose through the hole in the hose retainer.
Screw the cone end of the hose to the handset.
Screw the opposite end of the hose to the mixer.
Locate the hose cone into the slide bracket, ensuring that
it is fully inserted.
If the cone is not fully inserted, the handset may fall out
during use.
To adjust the angle of the handset, gently move the
handset just above the slider.
To move the slider, press the button and push or pull
the slider, you must always press the button to move the
slider.
