Equal Low Pressure
Installations.
Remove stream shaper using cache key.
Remove flow restrictor
in spout and
insert rubber washer before replacing
stream shaper
IMPORTANT
Please read all of the instructions before installation
This mixer is designed for all pressure systems above 0.35 bar.
This mixer is not recommended for use in uncontrolled heating systems such as wet-backs or
solar heating units.
NOTE: Base ring use is optional and should be used when required to ensure a seal is
achieved between the tap and basin. If fitting base ring please remove the o-ring from
the base of the tap body.
All pipework must be thoroughly flushed prior to the installation of the mixer. Inline filters (not
supplied) must be fitted on both hot and cold supplies to prevent foreign particles damaging
the ceramic cartridge.
Stream shaper
O-ring
Mounting stud
Mounting gasket
Mounting plate
Mounting nut
Flexible inlet hose:
cold
hot
Max 40mm
Ø 35mm
CORRECT
INCORRECT
DO NOT STRETCH OR TWIST HOSES
R35mm Min
20mm
Cold
Hot
DO NOT CRUSH
HOSE OR
SWAGED ENDS
