User Manual
8.1 Password Verification
“PA” stands for “Password”. ”0000” are the digits of the password.
Set the password by pressing the “Down” button to decrease the digit value, or “Up” to increase the value.
Password is 8888. Press the “ ” eight times (to get to 8) press “SET” button
and the marker will move to the next digit which
should automatically default to 8. Press “SET”
four
times to move onto the next setting.
8.2 ID Setting
After entering the password, the meter will ask for the address range. Enter 1 if you are not using Mbus.
Example below ”Id 00” shows that the current ID address is 00 (the ID address is hex code)
Address should be between 1 - 250
Use the “Down” button to decrease the digit or ”Up” to increase the digit value. Press the “SET” button to save the
digit and move onto the next digit.
8.3 Baud rate setting
Press “SET” button to bypass entering the Baud rate.
Press “Down” and “Up” buttons to select the communication baud rate, press “SET” button to save the setup.
The interface will enter CT setup.
Note:
The default baud rate will be set at 1200 bps
3MB100
ID 00
s a l e s @ m e t e r s . c o . u k | W h i t e L u n d I n d u s t r i a l E s t a t e L a n c a s t e r L A 3 3 B T | 0 1 5 2 4 5 5 5 9 2 9
8. PROGRAMMING
By holding the keys “SET” pressed for at last 3 seconds
The meter will go into programming mode.
Baud Rate = bits per second. This is the rate that devices exchange information online (on the RS485 network).
All devices MUST BE SENT at the SAME rate otherwise they cannot communicate.
Common Baud rate settings for M-Bus : 300; 2400
PA 0000
L1
L3
rev
L2
000375
.
5
000123456789
E M 7 3 5 - M o d
I E C 6 2 0 5 3 - 2 1 : 2 0 1 6
3 x 2 3 0 / 4 0 0 V 3 x 1 0 ( 1 0 0 ) A 5 0 /
6 0 H z
METERSUK
LTD
bd 2400
