METER ATMOS 14, Быстрый запуск, Страница: 2 / 2

ERROR OK
TEST
(–)
(+)
(–)
(+)
(–)
(+)
(+)
(–)
(+)
(–)
P1 P2 P3 P4 P5 P6
3. Plug Sensor In and
Configure Logger
Plug the sensor into the data
logger. Use data logger software
to apply appropriate settings to
the sensors plugged into each
data logger port.
1. Check Radiation Shield
Ensure the sensor is securely
installed in the radiation shield.
2. Install on Mounting Pole
Use the radiation shield mounting
bracket and V-bolt to mount the
radiation shield to the mounting
pole at the desired height.
Use a wrench to tighten the bolts,
securing the radiation shield to the
mounting pole.
Installation
ATMOS 14 QUICK START
Preparation
Inspect and verify ATMOS 14 components are intact. Installation will
require a mounting post.
Set up and test the system (sensors and data loggers) in a lab
or office. Ensure the data loggers are using up-to-date firmware
and software.
Read the ATMOS 14 User Manual at metergroup.com/atmos14-
support/ . All products have a 30-day satisfaction guarantee.
18268-01
1.31.2019
ATTENTION
ATMOS 14 requires the most current software and firmware
versions. Please make updates as necessary.
Em50
firmware version 2.27 or higher
EM60 firmware version 1.12 or higher
ProCheck
firmware version 1.69 or higher
ECH2O Utility version 1.83 or higher
ZENTRA Utility
version 1.12 or higher (with EM60)
Go to metergroup.com/environment/downloads to find the current
software or firmware version for the data logger being used.