6
Operation
Manual Use
1.
Ensure the slicer is turned off and that the thickness selection knob is set to “0”.
2.
Turn the function mode selector knob anti-clockwise to Manual.
3.
Pull back the carriage completely (towards the operator) to the loading position.
4.
Lift the end device up, into the rest position.
5.
Place product onto the table, the product will press against the fence plate because of its weight. Block it
with the end device by lowering it onto the product and pressing down slightly.
6.
Rotate the thickness selection knob anti-clockwise to the desired setting.
7.
Turn the slicer on by pushing the start button. The power indicator light, which is located between the on
and off switches, will illuminate.
DO NOT hold the food product with your hand. Never put your hand on or around the table while the slicer
is on. The end device handle is the only part of the slicer you should touch while slicing.
8.
Grip the handle attached to the meat table support and manually push the carriage back and forth. This
handle and the end device handle are the only part of the slicer you should touch while slicing. DO NOT
catch slices with your hands, let slices drop onto the receiving area.
If a product needs to be adjusted during slicing, first turn the slicer off and then pull the table all the way
towards you.
9.
When the weight or size of the product does not allow a proper slice, use the end device handle and apply
some pressure to the product.
10.
After the last slice stroke, pull the carriage all the way towards you. Turn the slicer off by pressing the stop
button, the power indicator light will go out. Turn the thickness selection knob clockwise until it stops to close
the slicer table.
11.
You can now unload the product from the table.
Automatic Use (Control Panel without Slice Counter)
1.
Ensure the slicer is turned off and that the
thickness selection knob is set to “0”.
2.
Turn the function mode selector clockwise to
the Automatic position.
3.
Pull back the carriage completely (towards
the operator) to the loading position.
4.
Lift the end device up, into the rest position.
5.
Place product onto the table, the product will
press against the fence plate because of its
weight. Block it with the end device by
lowering it onto the product and pressing
down slightly.
6.
Start the blade by pressing the
I
button of BLADE (c). The light (d1) will illuminate; this shows the normal
speed of the blade. Press (d) to increase or decrease the speed (3 different speeds).
7.
Regulate the thickness of the slice required and then start the carriage by pressing the
I
button of
CARRIAGE (e). The light (f) will illuminate.
8.
When the carriage starts moving, the lights that are on are (h1) = medium carriage speed and (i1) = the
longest stroke of the carriage.
9.
You can adjust the stroke and the speed of the carriage pushing the button (h) and (i), the corresponding
light will turn on to show the selection you have made.
10.
To turn the machine off first push the carriage stop button
O
(g), so that the carriage can go to its initial
position, and then turn the blade off by pushing the blade stop button
O
(a).
