6
Operation
Push Button Control Panel
1.
Off button
2.
Off button (light)
3.
On button
4.
On button (light)
5.
Speed button
6.
Speed button (light)
One LED on: low speed
Two LEDs on: Intermediate speed
Three LEDs on: High speed
7.
Stroke button (for carriage run)
8.
Stroke button (light)
One LED on: short carriage run Two LEDs on: Intermediate carriage run Three LEDs on: Long carriage run
Using the Slicer
Ensure the slicer is turned off and that the thickness selection knob is set to “0”.
Ensure that only one LED is lit on both the STROKE button and the SPEED button.
Manual Use
1.
Turn the function mode selector knob anti-clockwise to Manual.
2.
Pull back the carriage completely (towards the operator) to the loading position.
3.
Lift the end device up, into the rest position.
4.
Place product onto the table, the product will press against the fence plate because of its weight. Block it
with the end device by lowering it onto the product and pressing down slightly.
5.
Rotate the thickness selection knob anti-clockwise to the desired setting.
6.
Turn the slicer on by pushing the start button. The power indicator light, which is located above the switch,
will illuminate.
DO NOT hold the food product with your hand. Never put your hand on or around the table while the slicer
is on. The end device handle is the only part of the slicer you should touch while slicing.
7.
Grip the handle attached to the meat table support and manually push the carriage back and forth. This
handle and the end device handle are the only part of the slicer you should touch while slicing. DO NOT
catch slices with your hands, let slices drop onto the receiving area.
If a product needs to be adjusted during slicing, first turn the slicer off and then pull the table all the way
towards you.
8.
When the weight or size of the product does not allow a proper slice, use the end device handle and apply
some pressure to the product.
9.
After the last slice stroke, pull the carriage all the way towards you. Turn the slicer off by pressing the stop
button, the power indicator light will go out. Turn the thickness selection knob clockwise until it stops to close
the slicer table.
10.
You can now unload the product from the table.
