Metapace T-3, Руководство пользователя

Страница: 11 / 20

Rev. 1.00
- 11 -
Metapace T-3
1-4 Setting the Dip Switches
1-4-1 Serial Interface
• DIP Switch 1
SW Function ON OFF Default
1-1 Auto Line Feed Enable Disable OFF
1-2 Flow Control XON/XOFF DTR/DSR OFF
1-3 Data Length 7 bits 8 bits OFF
1-4 Parity Check Yes No OFF
1-5 Parity Selection EVEN ODD OFF
1-6 OFF
1-7 ON
1-8
Baud rate Selection (bps) Refer to the following Table 1
OFF
• DIP Switch 2
SW Function ON OFF Default
2-1 Auto cutter control Full cut Partial cut OFF
2-2 Internal bell control Internal bell disable Internal bell enable OFF
2-3 Auto Cutter Auto cutter disable
Auto cutter
enable
OFF
2-4 Reserved - - OFF
2-5 OFF
2-6
Print Density Refer to the following table 2
OFF
2-7 Near-End Sensor Status Disable Enable OFF
2-8 External buzzer control
External buzzer
enable
External buzzer
disable
OFF
1-4-2 Parallel & USB Interface
• DIP Switch 1
SW Function ON OFF Default
1-1 Auto Line Feed Enable Disable OFF
1-2 Reserved - - OFF
1-3 Reserved - - OFF
1-4 Reserved - - OFF
1-5 Reserved - - OFF
1-6 Reserved - - OFF
1-7 Reserved - - ON
1-8 Reserved - - OFF
• DIP Switch 2
SW Function ON OFF Default
2-1 Auto cutter control Full cut Partial cut OFF
2-2 Internal bell control Internal bell disable Internal bell enable OFF
2-3 Auto Cutter Auto cutter disable
Auto cutter
enable
OFF
2-4 Reserved - - OFF
2-5 OFF
2-6
Print Density Refer to the following table 2
OFF
2-7 Near-End Sensor Status Disable Enable OFF
2-8 External buzzer control
External buzzer
enable
External buzzer
disable
OFF