STEP 1
*If you are not using footplates, please go directly to STEP 2.
Bolt the footplate at the bottom of each upright, and add a
short shelf clip
, also called the "H" clip, (refer to Image C)
on the first level. This clip is intended to sup
-
port the
lower shelf when using a footplate.
STEP 2
While holding the 4 uprights, insert 4 shelf clips
and install the bottom shelf.
Either
1"
clips (
refer
to I
mage A)
or
2" clips (
refer to
Image B) are
provided
.
If you are also install
ing footplates
directly insert the bottom shelf on the
short shelf
clips. Then, insert the required shelf clips in the
top holes and install the top shelf.
Make sure the shelf clips are positioned
as shown on the right
STEP 3
Determine the shelves elevations and then place the shelf
clips onto the posts at the desired height. Install sides brace
with the supply bolts without tightening them to permit final
adjustments.
Do not use braces and end panels as they both serve the
same purpose
STEP 4
Using a screwdriver, angle the tips of the back brace in the proper position. Then, bolt the back braces on the
post. If you are using back panels, bolt them as shown.
A
.
B
.
Interlok
Installation Guide
(514) 937-9533 / (833) 937-9533
5
/
20
C
.
Only one short shelf clip is needed per each post, even if
side by side units are used.
2020-07
www.m
etalware.ca
