Setup Comms:
This will use the given Comms details to set the Servo Drives to use the Comms details specified in
the Calibrate Ports screen.
Note: This will send messages on the port using the settings specified here.
Upload Defaults:
This sends the Fasfold specific default settings to the Servo Drive.
Change Address:
This changes the Servo Drive on the specified address to the Address on the Calibrate Servo Drive
screen.
Next/Previous Page:
There is more than 1 page of settings for Servo Drives, this moves
between the pages.
Home Position:
This specifies if the Home Position is High or Low, or if the Axis
does not Home.
Maximum/ Minimum Position:
This specifies the Maximum/Minimum Position of the Axis.
Limit Switches:
Switches between the Limit Switches being Normally Open or Normally Closed.
Slow Distance:
The distance from the target to use the slow speed for.
Page 21
Instruction Manual for PB-70B (S902F)
04/12/2014
