Metal Man AB8550SGC, Инструкция по эксплуатации

Страница: 4 / 8

COMMON PROBLEMS AND REMEDIES
• Irregular Darkening Dimming
Headband has been set unevenly and there is an uneven distance from the eyes to the
filter lens (Reset the headband to reduce the difference to the filter).
• Auto-Darkening filter does not darken or flickers
①
Front cover lens is soiled or damaged (Change the cover lens).
②
Sensors are soiled (Clean the sensors surface).
• Slow response
Operating temperature is too low (Do not use at temperatures below -10º C or 14º F).
• Poor vision
①
Front / inside cover lens and / or the filter is soiled (Change lens).
②
There is insufficient ambient light.
③
Shade number is incorrectly set (Reset the shade number).
④
Check if removing the film on the front cover lens.
• Welding helmet slips
Headband is not properly adjusted (Readjust the headband).
WARNING
The user must stop using the auto-darkening welding helmet immediately
if the above-mentioned problems cannot be corrected. Contact the dealer.
INSTRUCTIONS FOR USE
WARNING! Before using the helmet for welding, ensure that you have
read and understood the safety instructions.
WARNING
Severe personal injury could occur if the user fails to follow the above
mentioned warnings and/or fails to follow the operating instructions.
2
• The helmet comes ready assembled but before it can be used it must be adjusted to fit
the user properly and set up for delay time, sensitivity and shade level.
• ADJUSTING THE FIT OF THE HELMET
TSensitivityhe overall circumference of the headband can be made larger or smaller by
rSensitivityotating the knob on the back of the headband (See adjustment “Y” in fig.1).
This can be done whilst wearing the helmet and allows just the right tension to be set to
keep the helmet firmly on the head without it being too tight.
• If the headband is riding too high or too low on your head, adjust the strap which passes
over the top of your head. To do this, release the end of the band by pushing the locking
pin out of the hole in the band. Slide the two portions of the band to a greater or lesser
width as required and push the locking pin through the nearest hole (See adjustment “W”
in fig.1).