COMMON PROBLEMS AND REMEDIES
• Irregular Darkening Dimming
Headband has been set unevenly and there is an uneven distance from the eyes to the
filter lens (Reset the headband to reduce the difference to the filter).
• Auto-Darkening filter does not darken or flickers
CD
Front cover lens is soiled or damaged (Change the cover lens).
®
Sensors are soiled (Clean the sensors surface)
®
Welding current is too low (Reset the sensitivity level to "higher'雨de)
• Slow response
Operating temperature is too low (Do not use at temperatures below -10
°
C or 14
°
F)
• Poor vision
CD
Front/ inside cover lens and I or the filter is soiled (Change lens).
®
There is insufficient ambient light.
®
Shade number is incorrectly set (Reset the shade number).
@ Check if removing the film on the front cover lens.
• Welding helmet slips
Headband is not properly adjusted (Readjust the headband).
氹
WARNING
Lf
、
The user must stop using the auto--<larkening welding helmet immediately
if the above-mentioned problems cannot be corrected. Contact the dealer
|
wARN
l
NG1
竺羣竺翌竺竺竺竺芸钅a
ty
o
uhave
|
• BATTERY INSTALLATION
Install batteries into helmet properly, according to
positive and negative terminal marking on
battery jar (See fig.1).
•TEST
Press and hold test to preview shade selection
before welding (See fig.2). When released then
viewing window will automatically return to the
light state (3 Shade).
• POWER
This ADF cartridge is powered by solar cell and 1
CR2450 lithium battery. Replace battery when
LOW BATTERY light is lit (See fig.1).
• SELECTING SHADE LEVEL
Select the shade level you require according to
the welding process you will use by referring to
Please notice the
anode and cathode
while mounting the
battery
fig.1
騙三三
fig.2
2
