Metabo KHA 18 LTX, Руководство по эксплуатации, Страница: 7 / 24

ENGLISH en
7
Only send the battery pack if the housing is intact
and no fluid is leaking. Remove the battery pack
from the machine for sending. Prevent the contacts
from short-circuiting (e.g. by protecting them with
adhesive tape).
Additional Warnings:
California Prop 65 08_2018
Some dust created by power
sanding, sawing, grinding,
drilling, and other construction activities
contains chemicals known to cause cancer,
birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
other masonry products, and
• Arsenic and chromium from chemicallytreated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic
particles.
Symbols on the tool:
.......Class II Construction
V...........volts
A...........amperes
Hz.........hertz
W .........watts
BPM .....beat per minute
....... direct current
n
0
.........no-load speed
rpm.......revolutions per minute
.../min ...revolutions per minute
See page 2.
1 Additional handle
2 Tool lock
3 SDS chuck
4 Depth stop
5 Switch button (for changing the operating
mode)
6 Lock
7 Carrying strap
8 Eyelet for securing the carrying strap
9 Rotation selector switch
10 Trigger
11 Handle
12 Capacity indicator button
13 Capacity and signal indicator
14 Battery pack
15 LED lights
16 Battery pack release button
*equipment-specific
5.1 Assembly of the additional handle
For safety reasons, always use the additional
handle supplied.
Open the clamping ring by turning the additional
handle (1) counter-clockwise. Push the additional
handle onto the collar of the machine. Insert the
depth stop (4). Securely tighten the additional
handle at the angle required for the application.
5.2 Battery pack
Charge the battery pack (14) before use.
If performance diminishes, recharge the battery
pack.
The ideal storage temperature is between 10°C and
30°C.
Li-Ion battery packs "Li-Power" have a capacity and
signal indicator (13):
- Press the button (12), the LEDs indicate the
charge level.
- If one LED is flashing, the battery pack is almost
flat and must be recharged.
5.3 Removing and inserting the battery pack
Removal: Press the battery pack release button
(16) and pull the battery pack (14) forwards .
To insert: Slide the battery pack (14) in until it
engages.
5.4 Carrying strap
If necessary, hang the hook on the Metabo carrying
strap (7) on the eyelet (8). Set the carrying strap (7)
to the desired length.
Carrying:
To prevent unintentional start-up, move the
rotation selector switch (9) to centre position
(transporting safety device).
Never carry with a tool
inserted.
The machine must only be carried with the
Metabo carrying strap (7) across chest and
back (illustration a, page 2). Hold the machine
steady.
The machine must NOT be carried with the carrying
strap (7) around your neck (illustration b, page 2).
6.1 The machine's multifunctional
monitoring system
If the machine switches off automatically, the
machine electronics have activated automatic
protection mode. A warning signal sounds
(continuous beeping). The beeping stops after a
maximum of 30 seconds or when the trigger (10) is
released.
In spite of this protective function, overloading
is still possible with certain applications and
can result in damage to the machine.
4. Overview
WARNING
5. Commissioning
6. Use