Detach the reversible blades (10) using the
sharp-pointed tool and clean the contact
surface of the blades.
Replace the reversible blades (10) so that the
blades once again present a sharp edge as
they rotate.
If all of the cutting edges are worn blunt,
replace the reversible blades.
Always turn or replace both
reversible blades at the same time.
Replace and screws with damaged
Torx heads.
Apply a torque of 5 Nm to secure reversible
blades after turning or replacement.
Do not forget to remove the Torx
spanner!
8.3
Cleaning the cutterhead and contact
surface of the planing base
If the cutterhead requires cleaning, use a
cleaning material suitable for use with
aluminium (pH value between 4.5 and 8).
8.4
Cleaning the vacuum extraction
nozzle
During operation it is possible that chips may
lodge in the extraction nozzle and block it.
Insert the sharp-pointed tool (7) into the
cleaning slit in the extraction nozzle to loosen
and remove any chips causing a blockage.
Remove the extraction nozzle (5), if necessary.
To remove, turn out the cross-head screws
and pull the extraction nozzle out to the rear.
Clean the extraction nozzle and the planing
base (9).
9 Repairs
Repairs to power tools must be
carried out by a qualified electrician
only.
Any Metabo power tools in need of repair can
be sent to one of the addresses listed in the
spare parts list.
Please send the tool for repair with a brief
description of the fault identified.
10
Environmental Protection
Metabo packaging is 100% suitable for
recycling.
Power tools and accessories at the end of
their service life still contain large amounts of
valuable raw materials and plastics which can
likewise be fed back into a recycling process.
Make suitable arrangements for the disposal
of the chips created during operation.
These Operating Instructions are printed on
paper produced in a chlorine-free bleaching
process.
Only for EU countries: Never dispose
of power tools in your household
waste! In accordance with European
Guideline 2002/96/EC on used electronic and
electric equipment and its implementation in
national legal systems, used power tools must
be collected separately and handed in for
environmentally compatible recycling.
11 Technical Specifications
Notes on the details on page 2.
We reserve the right to undertake
modifications to reflect technical advances.
P
1
= rated input
P
2
= output power
a
hw
= typically rated acceleration in the
hand-arm area
Typical A-rated acoustic level:
L
pA
= acoustic pressure level
L
WA
= acoustic power level
K
pA
,K
WA
= uncertainty
Wear ear protectors!
m
= weight
Measured values established according to
EN 60745. The stated technical specifications
are subject to tolerances (as specified in the
respective current standards).
15
ENGLISH
