Incline wing-nut
Incline lever
Loosen
A
Loosen
Stopper lever
Fig. 16
Tighten
Tighten
Incline wing-nut
Incline lever
Stopper lever
B
Fig. 17
Always ensure that the wing-nut is thoroughly
tightened after making the desired adjustment.
NOTE
Values of the inclined gauge provided on the base
merely serve as a rough guideline. For cutting
operation at an inclined precise angle, use the circular
saw after adjusting the angle between the base and
the saw blade with a protractor, etc.
3. Fine tuning of parallelism
It is possible to
fi
ne-tune the parallelism of the saw
blade to the base using the parallelism adjustment
screw.
Adjustment has already been made at the time of
shipment from the factory. However, in the unlikely
event of parallelism being faulty, adjust as follows.
(1) Unfasten only the mounting screws of the saw cover
hinge portion (Fig. 18).
5
Fig. 18
(2) Retract the lower guard into the saw cover.
(3) Insert wood chip in the rear side of the saw blade
base, and mark the position on the base (Fig. 19).
Fig. 19
(4) Move the marked wood chip to the front of the base,
and turn the parallelism adjustment screw so that the
marking corresponds to the base side (Fig. 20).
Fig. 20
NOTE
After parallelism adjustment, if the saw cover hinge
portion is loose, tighten the M5 U-Nut. Do not over
tighten the nut as this may result in deformation of the
bevel plate.
18
English
00Book̲C18DBAL̲NA̲metabo.indb 18
00Book̲C18DBAL̲NA̲metabo.indb 18
2021/03/30 17:20:59
2021/03/30 17:20:59
