T.2+ INSTALLATION MANUAL
EN
5040
XXXXXX
KIT COMPOSITION
INSTALLATION
Power Supply: ..................................................................................12Vdc (9V-14V)
Working temperature: ..........................................................from -30°C to +80°C
IP: .....................................................................................................................................40
Application classifi cation: ...........................................passenger compartment
TECHNICAL SPECIFICATIONS
WARNINGS
• ALL INSTALLATION OPERATIONS MUST BE CARRIED OUT WITH THE MOTOR OFF.
• Before starting installation, detect the OBD port location referring to the use and maintenance manual of the
vehicle.
• If the OBD connector should be used for other purpose, such as maintenance, remove T2+ and, after tempo-
rary operation, reconnect the T2+ to OBD connector.
• Strictly comply with operations indicated in this manual.
• Installation staff are not authorised to remove warranty seals and/or access the inside of the product.
• The device must be connected to OBD port on board to the vehicle, provided with protected power supply
by means a 5 A fuse maxiumum activation current.
• The manufacturer assumes no responsibility for damages caused to property and/or people, caused
by the incorrect installation of the product.
TELEMATIC CONTROL UNIT
1
2c
2b
OBD PORT
By using user manual of the vehicle fi nd
the OBD connector on your car.
Typically OBD plug can be located:
• near the breaks unit
• near the fuse box
• under the dashboard
• in the middle console
Plug the connector into the vehi-
cle’s OBD.
Lock the Secondary Lock to se-
cure the device.
2a
Check that the device is fully
connected and does not unlock.
