Met One E-BAM, Руководство по эксплуатации

Страница: 10 / 64

E-BAM-9805 Manual Rev B.docx Page 10
Application and installation dependent accessories for the E-BAM are also available from Met One
Instruments, Inc. Common optional items are shown in Table 2-2.
Common Optional Component Part No.
Wind Speed and Direction Sensor EX2-034B or EX2-AIO
Volumetric Flow Calibration Kit BX-307
Zero Filter Kit BX-302
Table 2-2 Optional E-BAM Accessories
2.3 Assembling the E-BAM
The E-BAM is designed to be field deployable by an average person in less than 15 minutes under
normal conditions. Refer to the photos and diagrams below while performing the following steps to
assemble the unit:
1. Deploy the tripod: Remove the three stainless steel detent pins from the tripod base by
pulling the rings. Unfold the three tripod legs and reinsert the three pins so that each pin
secures a leg in the open position. Make sure the erected tripod is rigid and stable.
Figure 2-1 Tripod Deployment
2. Install the E-BAM onto the tripod: Lift the E-BAM assembly and slide the slot on the back
of the E-BAM over the tab on the top of the tripod. Insert the supplied ¼- 20 bolt through the
tab on the bottom of the E-BAM and through the hole in the body of the tripod (see Figure
2-2). Secure it with the supplied washers and nut. This prevents the E-BAM from shifting on
the tripod.
3. Install the inlet components: Loosen the weatherproof fitting on top of the E-BAM and
insert the short inlet tube into the top of the unit. The tube must go through the fitting and
through two O-rings in the top of the E-BAM.
Make sure the tube is fully seated by rotating it
back and forth. Tighten the weatherproof fitting to secure the inlet tube. For PM
10
monitoring,
install the BX-802 PM
10
inlet directly onto the top of the short inlet tube. If a BX- 807 cyclone
is to be used for PM
2.5
monitoring, it must be installed under the PM
10
head as shown in
Figure 2-2 . Lubricate the O-rings as necessary.
Detent Pins