opto
LAN
Date:
11/15/11
Manual - Appendix
Page A1
Appendix: Details and operation
The following chapter describes special details of the
opto
LAN
system for
the transmission of ethernet signals. The system consists of two
transceivers.
a)
Housing and connectors / switches
Fig. a.1 shows the front side of the transceivers with connectors and
switches:
•
power push button with control LED (
Pwr On/Off
)
•
battery information LED (
Info
)
•
charge plug (
Charge
)
•
optical connector FSMA (
Optical In .. Out
) for duplex multimode
fiber (62,5/125µm)
Fig. a.2 shows the rear side of the transceivers with RJ45 connector.
(standard ethernet pinning):
•
RJ45 plug
LAN I/O 10/100Mbit/s
for the ethernet signals to be
transmitted.
Fig. a.1: Front side of the devices with connectors and push buttons
Fig. a.2: Rear side of the devices with connectors and switches
Front side with
connectors and push
buttons
Rear side with
connector. Pinning is
printed on the
housing too.
Charge
Pwr
Info
On/Off
Optical
In Out
LAN I/O
10/100Mbit/s
Distributed by: Reliant EMC LLC, 3311 Lewis Ave, Signal Hill CA 90755, 4089165750, www.reliantemc.com
