Messoa UFD301, Быстрый старт, Страница: 9 / 20

Quick Start Guide
8
3 Connection
3.1 Network Topology
The unit, which is equipped with Ethernet RJ-45 network interface, can deliver video images and audio in real
time via either Internet or Intranet. Please refer to the skeleton drawings shown below for understanding.
Figure 2 - 6: Network Topology
3.2 Accessing the Camera for the First Time
The camera comes with a web-based setup utility, allowing you to view the video of the camera and configure
the camera for optimal use in your environment. Take the following steps to connect your PC to the camera.
Step 1: Make the connection
For initial setup purposes, connect one end of an Ethernet cable to the RJ-45 connector of the camera and
the other end to the LAN port on your PC.
Step 2: Configure your PC’s IP address
The camera uses a default IP address of 192.168.1.30 and subnet mask of 255.255.255.0. To have your PC
on the same network with the camera, configure your PC’s IP settings as below:
 IP address: 192.168.1.X, where X is a number between 2 to 254, excluding 30.
 Subnet mask: 255.255.255.0.
Step 3: Link Verification between PC and Camera
1. Launch the Command Prompt by clicking the Start menu, Programs, Accessories and then Command
Prompt .
2. At the prompt window, type ping x.x.x.x , where x.x.x.x is the IP address of the camera (the default is
192.168.1.30). If the message of “Reply from…” responds, it means the connection is established.
Step 4: Accessing the Camera from IE Browser
Open the IE browser and enter the IP address of the camera in the URL field. The default is 192.168.1.30.
When prompted for login, enter the user name and the password (The defaults:
admin, 1234 ). Note that the
user name and password are case-sensitive.