MEA
EWR
User’s
Guide
3.4 EWR6300
Mounting
Bracket
The mounting bracket for the IAP6300 and the MWR6300 are identical to mounting bracket for
the EWR6300. The bracket is robust secure; and can be used for horizontal, vertical, and off-
angle pole mounted installations. The mounting bracket is preinstalled and supplied with two 3
1/2 x 1/4 inch stainless steel bolts. The mounting bracket can accommodate up to a 3 1/4 inch
diameter mounting pole. Substitute for the 1/4-inch bolts supplied with the bracket may be used
to accommodate mounting poles smaller than 3 inches.
MeshNetworks strongly recommends the use of stainless steel mounting hardware to prevent
corrosion. The standard mounting hardware supplied with the bracket is stainless steel. The
bracket is made of aluminum.
The following procedure outlines the required steps for installing a MEA EWR6300 the bracket
shown in
Figure 3-19. EWR6300 Mounting Bracket
Using the deployment guidelines described in the
mea Setup and Deployment User’s
Guide
, locate an appropriate mounting pole such at a streetlight cobra arm or a metal
post. The mounting pole can be vertical, horizontal, or project at almost any angle.
1.
2. Remove one of the C-Clamp Bracket bolts so that the bracket can be positioned around
the mounting pole. If necessary, remove the second bolt. When the two halves of the
Clamp Bracket are correctly positioned, reinstall the bracket bolts.
Note:
The C-Clamp Bracket Assembly requires two 3 1/2 x 1/4 inch stainless steel bolts
to secure the C-Clamp to a mounting pole. Each bolt is supplied with (2) stainless steel
flat washers, (1) lock washer, and (1) stainless steel nut. The bracket hardware should
be installed as indicated in
.
27
