Meru Networks AP433e, Руководство по установке, Страница: 27 / 61

5 Installing AP433i & 433is
This chapter describes how to install and configure an AP433i & 433is, which is
supported on System Director Version 6.0-SR1 and later. It contains the following
sections,
•
Safety Precautions
•
Unpack the AP433i & 433is
•
Determine Power Requirements
•
Installation Requirements
•
Install the AP433i & 433is
•
Check AP433i & 433is LED Activity
•
Where to Go From Here
5.1 Note
This document depicts installation procedures for the AP433i and 433is models.
Since both devices are externally identical, the same procedures can be used for
either device.
5.2 Safety Precautions
IMPORTANT—Read and follow the regulatory instructions in Appendix B before
installing and operating this Product.
The AP433i & 433is is intended only for installation in Environment A as defined in
IEEE Std 802.3af and 802.3at. All interconnected equipments must be contained
within the same building, including the interconnected equipment's associated
LAN connection.
5.3 Package Content, AP433i & 433is
Confirm that the AP433i & 433is shipping package contains these items:
•
AP433i or AP433is
•
Plastic attachment (used when paddle antenna is disconnected)
•
Wall mounting bracket
•
Rubber feet
•
Locking pin
•
Two mounting screws
5.4 Determine Power Requirements
Power requirements vary, depending on which AP433i & 433is radios are
deployed and what MIMO mode is used. See the chart below for supported power
sources for different radio configurations.
Table 5, Power Source & Radio Supported in AP433
Power Source Radio Supported
IEEE Std 802.3af Radio 1 and Radio 2
IEEE Std 802.3at Radio 1, 2, and 3
5.4.1 IEEE Std 802.3af PoE Usage
When using System Director V6.0 SR2 (or earlier Version) and an IEEE Std