GB
The USB interface, flush-mounted allows linking to a PC
for addressing, programming and diagnosis of KNX
components with USB1.1 or USB2 interfaces.
The device has an integrated bus coupler and is
connected to the bus with a bus connecting terminal.
Power is supplied entirely from the connected PC via
the USB interface. The USB interface is recognised by
the KNX system when the USB cable is plugged in. The
device is programmed with the physical address locally
only via the connected PC and therefore does not have
a programming button or a programming LED.
The firmware for the USB interface can be updated via
a PC and is therefore future-proof for any later
standards.
The USB interface is provided for screw assembly in a
size 60 installation box.
For combination with the central plate for telephone
socket-outlet TAE (e.g. Art. no. 2960.., 2979.., 2978..,
2928.., 2938..).
|
Common covers for 230 V devices and low-
voltage devices are allowed for flush-mounted
switches and socket-outlets with screwless
terminals. Observe the relevant regulations.
What you can do with the USB interface,
flush-mounted
¼
Risk of fatal injury from electrical current.
All work carried out on the device may only be
performed by skilled electricians. The country-
specific regulations and the valid KNX guidelines
must be followed.
1
Connect bus connecting terminal on the back of
the USB interface (figure
!B
).
2
Install the USB interface in a flush-mounted box at
least 20 mm deep.
3
Break open the openings of the TAE cover.
4
Screw the TAE cover onto the USB interface.
5
Connect the USB cable to the USB connection
(figure
!A
).
Figure
!
:
A
USB connection
B
Bus connecting terminal
For your safety
How to install the USB interface
Technical data
Power supply:
via PC USB interface
Connection
Bus:
Bus connecting terminal
USB interface:
USB socket, type B
Transmission rate:
9600 baud
Transmission log:
compatible with USB 1.1/
2.0
Cable length USB cable:
max. 5 m
Ambient temperature:
-5 °C to +45 °C
Storage temperature:
-25°C to +70°C
Type of protection:
IP 20
Protection class:
II
Mounting width:
36 mm (2 modules)
A
B
Merten GmbH & Co. KG,
Solutions for intelligent buildings
Service Center, Fritz-Kotz-Straße 8,
Industriegebiet Bomig-West
D-51674 Wiehl
Phone: +49
2261
702-204
Fax: +49
2261
702-136
E-Mail:
Internet: www.merten.de
InfoLine:
Phone:
+49 1805 212581* or +49 800 63783640
Fax:
+49 1805 212582* or +49 800 63783630
E-Mail:
* fee required
USB interface, flush-mounted
Operating instructions
Art. no. 681799
