Detection area
Detection area can be reduced by selecting the combination on the
DIP switches to fit precisely each application .
MC601V
Setting
Hold time
Refers to the time period the lamp remains at 100% illumination after no
motion detected.
Stand-by period
Refers to the time period the lamp remains at a low light level before it
completely switches off in the long absence of people.
When set to“ ”mode, the low light is maintained until motion is detected.
Stand-by dimming level
The low light level you would like to have after the hold time in the long
absence of people.
Daylight sensor
The sensor can be set to only allow the lamp to illuminate below a defined
ambient brightness threshold.
When set to Disable mode, the daylight sensor will switch on the lamp when
motion is detected regardless of ambient light level.
50lux, 30lux: twilight operation, 10lux, 5lux: darkness operation only.
Note that daylight sensor is active only when lamp totally switches off.
By selecting the combination on the DIP switches, sensor data can be precisely set for each specific application.
ON
ON
ON
Operating voltage 120~277Vac, 50Hz/60Hz
Rated capacitive load 120V@400W;220-240V@800W;277V@1000W
HF system 5.8GHz±75MHz, ISM wave band
Transmitting power <0.5mW
Power consumption
≤
0.5W(standby), <1W(operation)
Detection zone Max.(D x H): 16m x 15m
Detection sensitivity 10% / 50% / 75% / 100%
Hold time 5s / 30s / 90s / 3min / 20min / +
Daylight sensor 2lux/5lux / 10lux / 25lux /50lux / 100lux / Disable
Stand-by period 0s /5s / 5min / 10min / 30min / 1h / +
Stand-by dimming level 10% / 20% / 30% / 50%
Mounting height 15m Max.
Motion detection 0.5~3m/s
Detection angle
150°(wall installation),
360°(ceiling installation)
Operating temperature -35
℃
~70
℃
IP rating IP20
ON
8
8
