Merrylock MK 4055, Инструкция

Страница: 14 / 33

E D C
Cover stitch right needle
Cover stitch middle needle
/ Chain stitch needle
Cover stitch left needle
Be sure to disconnect the machine from the
electric outlet before removing needle(s).
Chain stitch needle thread
Left, middle and right cover
stitch needle thread
Flat surface to the rear
(1) NEEDLE POSITION
* With this machine, five needles can be inserted to
the needle clamp as shown in the drawing but
only one or two or three needles are to be used
for cover stitch sewing.
Note : Do not attempt to use four or five needles.
* The Instruction Book refers to different needle
positions by illustrating the needle clamp at right.
Note : When all cover stitch needles are inserted,
the left needle will be slightly higher than the
others.
1
(2) TO REMOVE NEEDLE (S)
9. HOW TO REMOVE AND INSERT
NEEDLES
* Turn the hand wheel toward you until the needles
are
the
the fabric.
* Loosen, but do not remove the needle clamp
screw with the allen key while you are holding the
needles.
C. Cover stitch left needle
D. Cover stitch middle needle
E. Cover stitch right needle
at their highest position.
* Place a thick piece of fabric [such as felt] under
presser foot. Lower the needles halfway into
Note: After removing the specific needle which is
not currently to be used for sewing, remember to
fasten the set screw in the screw hole of the needle
clamp and to just fasten tight into the hole.
Please do not over-tighten the screw into the hole
or the needle clamp will be damaged.
13
C
E
D
D
C
E
D