Standing the Reformer Upright
Please read these instructions completely before beginning or refer to our online assembly video at: merrithew.com/eq-assembly
2.
Move the chrome adjuster bar
[6]
to set
the footbar
[7]
into the lowest position.
5
. Position all five springs
[
28
]
in the
gearbar
[
8
]
.
8.
Using your foot, pull out one leg of the
Stand
[54]
, until it is fully folded out and in
line with the Reformer rails
[
14
]
. Repeat for
the Stand on the other side.
It is strongly recommended that
footwear is worn during this step.
9.
Ensure that the Floating Safety Tabs
[53]
on both sides are hanging vertically
just above the chrome adjuster bar
[6]
.
Wiggle the Reformer slightly to ensure the
Reformer is solidly set in place.
Be sure to select a level area when
storing your Reformer upright.
1.
If attached, first remove the vertical
frame or Accessory Boards such as a
Jumpboard, Cardio-Tramp, Rotational
Diskboard, etc.
Refer to Page 20 of the Reformer Owner’s
Manual for instructions on removing the
vertical frame.
4.
Place the carriage stopper
[47]
in the
second position.
7.
To stand the Reformer, lift it upwards,
while carefully moving one hand and then
the other, to the side rails
[
14
]
. Continue
lifting the Reformer until it is fully upright
and resting on the footbar
[7]
[
fig. A
]
.
Two people are required for this
step. When standing and storing this
Reformer, choose a low traffic area,
away from children, pets, windows
and mirrors.
3.
Place the gearbar
[8]
in the
second position.
6.
Grasp the front end crossbar with
both hands and lift the Reformer.
Keep the Reformer below 48"/122 cm
(approximately waist-height) to prevent the
frame from making contact with the floor.
Roll the Reformer to the storage area.
Take care when lifting the Reformer
to avoid injury.
A
3
