6
Halo Trainer
®
Owner’s Manual
Inflating the Stability Ball
CAUTION! Inflate a new ball in stages and not all at once.
1.
Remove Stability Ball from box and check for damage.
It is normal to have mild creases or fold marks when first inflated.
This will dissipate with use.
2.
Before inflating allow the Stability Ball to reach
room temperature.
3.
Remove the white plug from the Stability Ball.
Attach pump inflator tip to one end of pump hose.
Place the other end of the pump hose into the blue port
at the base of the pump.
4.
Insert the inflator tip into hole in Stability Ball. Inflate Ball
to the desired height and firmness.
Do not over-inflate.
When properly inflated the Halo Trainer should fit snuggly
around the upper third of the Stability Ball.
5.
Remove inflator tip from Ball and immediately replace
with the white plug so that it is flush with the Ball when
fully inserted.
NOTE:
After initially inflating, leave it overnight and
continue inflating the next day.
Re-inflate the Stability Ball as necessary to keep it at the ideal size
and density. It is good practice to inflate a second time one to
two days after initial inflation. Mild leakage of air may occur over
time and with use.
Care and Cleaning
Wipe Long Bar and Short Handle Grips with a mixture of
water and tea tree oil, a natural disinfectant. Add 1 tsp
of tea tree oil to a 1 L or 1 quart spray bottle of water.
A mixture of mild soap and water may be used to remove
more persistent dirt. Ensure cleaner does not leave an oily
residue, or make surfaces slippery. Clean all metal surface
areas as required, using a soft cloth and gentle cleaner.
CAUTION:
Avoid chemical-based products.
To extend the life of the Halo Trainer, do not expose it
to prolonged sunlight, moisture, or extreme hot or cold.
We recommend protecting the Long Bar and Short Handle
Grips by not using the Halo Trainer on abrasive surfaces such
as concrete. Avoid exposing the Stability Ball to rough or
sharp surfaces. Clear the workout area of any sharp objects
that may puncture the Ball.
Use only on smooth surfaces.
ASSEMBLY INSTRUCTIONS
