Reformer Owner’s Manual
4
8
11
12
1.
Lower the footbar [8] by adjusting the
swing arm [11] of the Reformer to cradle
position #4 [12].
2.
Slide the rods of the Jumpboard Frame
[6] (with Cross-Bow attached) completely
into the receptacles [9] in the wooden
standing platform.
5.
Attach Cross-Bow with the new
bolts and washers [14, 15] provided.
Tighten using the adjustable or 7/16"
open wrench. Confirm all hex bolts [14]
are tightly secured and check regularly
as instructed in the “Mechanical
Safety Check”.
1.
Insert Cross-Bow [1] handle into
Cross-Bow (receptacles) frame [5].
Ensure the pop-up pin [4] and stud
knob [3] are loosened (unscrewed)
before attempting to pull out.
2.
Place the Jumpboard, vinyl side down
on a smooth flat surface.
3.
Remove the 4 hex bolts from the
Jumpboard frame [6] with an adjustable or
7/16" open wrench. It is recommended to
keep the original bolts.
4.
Place the Cross-Bow as shown aligning
the bolt holes.
ASSEMBLY INSTRUCTIONS
Assembling the Cross-Bow
Please read these instructions completely before starting.
w
Place all parts from the box in a cleared area and position them on the floor in front of you.
w
Remove all packing materials from the area and place them back into the box.
Do not dispose of the packing materials until assembly is completed.
w
To prevent unsafe or improper use, please read each step carefully before beginning.
Inserting the Cross-Bow and Jumpboard
3.
Tighten both star knobs [10] to ensure
the Jumpboard is securely in place.
10
6
9
INSTALLATION
6
14
15
1
3
5
4