EDR4 1169 G 10/03
15
WARNING Door may move suddenly when released.
Do not use the manual release cord to pull the door open.
The cord or release may break under load.
To disengage the opener
Pull the release cord down.
To re-engage the opener
Push the lever (attached to the red release cord) upwards
and move the door manually to allow the torpedo to en-
gage inside the trolley.
Operating from a remote control
transmitter
Your remote control transmitter has two buttons. One
large button and one small button. You can control
two products or two functions with the two buttons.
For example a gate opener and a garage door opener.
A press on the a remote control transmitter button
will open, stop or close the door
If your remote control transmitter has no effect, move
closer to the opener. Radio signals can be blocked
or reduced by many external factors. There is a bat-
tery inside the remote control transmitter which requires periodic replacement. A fresh bat-
tery will give better performance than an old battery.
Trouble shooting
There are no user serviceable parts inside the opener. The power cord is not intended for
replacement by the user. Please refer to your Merlin dealer in the event that replacement is
required. Contact your Merlin dealer or Authorised Merlin Installer for any service require-
ments.
Opener does not work at all.
May be no power. If the lamp is still on then the motor may have temporarily shut off to cool
down.
SOLUTION: Plug another appliance into the power point to check power. Wait 5 min-
utes for the motor to cool.
Courtesy lamp flashes when door stops.
This is a warning that your door was obstructed and couldn’t reach its normal stopping
position. Your door may have become heavy to operate. SOLUTION: Look for a anything
blocking the beam sensor. Is the beam aligned correctly? Release the manual release and
Remove visor
clip. Press cover
down then slide
off to expose
battery.
Transmitter
buttons
Release cord and lever
Push up to
re-engage
Pull down
to release
