3
Figure 3
Figure 4
4. Press the desired channel button to program
another channel. Repeat programming procedures
in steps 2 and 3 above.
5. When finished programming each desired channel,
momentarily press the
PRINCE CASTLE
logo to
end the Program Mode. This saves the program
changes you have made for all channels.
See figure 5.
Figure 5
6. You can change the sound level of the alarm in
RUN MODE
. Press and hold the
PRINCE CASTLE
logo; then, within six seconds, press either the
SCAN UP
Arrow button or the
SCAN DOWN
Arrow
button. The
SCAN UP
Arrow button adjusts the
sound level to the louder alarm, the
SCAN DOWN
Arrow button adjusts the sound level to the lower
alarm.
OPERATION
1. Press a channel button to activate a timing cycle.
(All channels can be activated and running at the
same time.) The time remaining will countdown in
the
TIME
display, and the time value
M:S
or
H:M
will
be illuminated. See figure 6
Figure 6
2. Press the desired channel button three times within
five seconds to cancel an active timing cycle.
IMPORTANT:
The channel timer button’s multicolored
LED indicator shows the status of the timer. The
indicator has three colors: green, yellow, and red. The
LED will be green during the first 70% of the count-
down. It changes to yellow during the next 20% of the
countdown. It will be red during the final 10% of the
countdown, and will start flashing red once the time
has run out.
3. The timer will countdown from the programmed
value to zero. At zero, the display flashes
End
and
the alarm sounds. See figure 7.
Figure 7
4. When the timing cycle is complete, and the alarm
sounds, press the channel button to cancel the
alarm. See figure 7.
59:59
P r o g
P r o g
P r o g
P r o g
P r o g
1:00
P r o g
P r o g
P r o g
P r o g
P r o g
- - - -
- - - -
- - - -
- - - -
- - - -
- - - -
3:00
- - - -
- - - -
- - - -
- - - -
- - - -
End
- - - -
- - - -
- - - -
- - - -
- - - -
740-521revA
Printed in USA 3/06 © 2006
